In the City of Wanneroo, whether a block can be split starts with its density code (R-Code) and zoning. The City's District Planning Scheme No. 2 (DPS2) maps a code for established areas, while many newer areas are planned through structure plans that set their own codes. Table D of the state Residential Design Codes (R-Codes) then sets the minimum and average lot sizes, and the Western Australian Planning Commission (WAPC) makes the decision.
Wanneroo also has its own rules for split codes such as R20/R40, a separate policy for rural lots, a policy on karst (cave) risk, and developer contribution areas. Figures are as at November 2026.
Which planning scheme applies in the City of Wanneroo
The operative scheme is City of Wanneroo District Planning Scheme No. 2, first gazetted on 6 July 2001. The Department of Planning, Lands and Heritage's current copy of the scheme text is updated to Amendment 232, gazetted 6 October 2026, and the department publishes it with 24 locality scheme maps and the City's approved structure plans.
Clause 4.1(3) says the R-Code coding of land "is shown by the coding number superimposed on a particular area" of the Scheme Map.
How to find your lot's R-Code
- The City's online mapping (IntraMaps). The City says it shows information including zoning, area, dimensions and address, and its written planning advice page says that for residential properties "the applicable density code (R-Code) will be shown".
- DPS2 scheme maps. The department publishes these by locality, from Two Rocks to Marangaroo.
- Structure plans and local development plans. The City lists its approved structure plans and local development plans online, and PlanWA shows structure plans approved by the WAPC after 19 October 2015.
- Written planning advice. You can apply to the City for written advice on a specific planning matter, with fees set by its Planning Fee Schedule.
Structure plan areas set their own codes
Approved structure plans cover areas including Alkimos, Butler, Yanchep and the East Wanneroo cells. The WAPC's Guidance for Structure Plans says:
- Structure plans for residential or mixed-use areas "must designate R-Codes on the structure plan map".
- A structure plan is "given due regard in decision making". Decision-makers are not legally bound by it, but must use it in deciding proposals.
- A structure plan has effect for 10 years from WAPC approval, or a longer period the WAPC approves.
In some estates the codes are R-MD codes. The City's Local Planning Policy 4.19 applies where an approved structure plan says R-MD standards apply, and sets standard lot types for R-MD25, R-MD30 and R-MD40. An R-MD40 rear-loaded lot, for example, is 7.5 m by 30 m (225 m²). Local development plans can add lot-specific controls, so check both documents for your street.
Split codes such as R20/R40
Clause 4.2(4) of DPS2 says that where a split residential density code is shown on the Scheme Maps, development "shall conform to the lower density code applicable to the lot" unless the City determines that development up to the higher code is appropriate. Both of these criteria must be met:
- sufficient capacity in all necessary public utility services to meet the needs of the development, and
- no more than one consolidated vehicle access point for each street frontage of the lot.
For subdivision, clause 4.2(5) says split-coded land "should not result in the need for additional crossovers" to those already available. The City should recommend a right of carriageway easement between the new lots and a restrictive covenant on the titles to keep access consolidated. Under clause 4.2(6), split-coded land directly abutting Wanneroo Road or Mirrabooka Avenue needs a Noise Management Plan with any subdivision application.
As an example, Amendment 158 (gazetted 21 October 2016) recoded three properties in Girrawheen, Marangaroo and Wanneroo from R20 to R20/R40.
Housing precincts
Local Planning Policy 3.1 guides higher-density recoding in five Housing Precincts in Wanneroo, Koondoola, Girrawheen, Yanchep and Two Rocks. It uses distance criteria, such as R60 within 400 m of neighbourhood and town centres and R40 from 401 m to 800 m, and R60 within 200 m of a rail station. The code that applies to your lot is still the one shown on the scheme map or structure plan.
Lot sizes for common codes
These figures are from Table D of the R-Codes Volume 1 (Version 3, 10 April 2026) for single houses and grouped dwellings.
| R-Code | Minimum site area (m²) | Average site area (m²) | Rear battle-axe minimum (m²)* | Minimum frontage (m)* |
|---|---|---|---|---|
| R20 | 350 | 450 | 450 | 10 |
| R25 | 300 | 350 | 425 | 8 |
| R30 | 260 | 300 | 410 | – |
| R40 | 180 | 220 | 380 | – |
| R60 | 120 | 150 | 120 | – |
*Table D applies these two columns to single houses only. A dash means not applicable.
Both tests apply. At R20, two lots generally need at least 900 m² between them, and at R40, at least 440 m². For the full table and the five per cent variation, see the minimum lot size for subdivision in WA. For rear lots, see battle-axe subdivision explained.
Sewer comes first
Clause 4.2(3) of DPS2 says "development in excess of a single dwelling shall not be permitted in unsewered areas" unless it accords with the Government Sewerage Policy – Perth Metropolitan Region, or the health department recommends a variation because of exceptional circumstances. Water Corporation's standard infrastructure contributions for 1 July 2026 to 30 June 2027 are $2,756 for water and $5,121 for wastewater per lot, plus $41 for drainage in urban declared drainage areas (not strata). They are not subject to GST.
Rural land: separate minimum lot sizes
Rural lots are not assessed against Table D. The City's Local Planning Policy 4.9 (Subdivision of Rural Zoned Land, authorised 16 October 2018) sets out what the City will support in the General Rural and Rural Resource zones, including:
- a minimum of 4 ha per lot south of Neaves Road (excluding land identified for future urban or employment use under the East Wanneroo Structure Plan)
- a minimum of 20 ha in the Rural Resource zone north of Flynn Drive, where lots under 8 ha will not be supported
- a minimum of 20 ha west of Wanneroo Road between Romeo Road and Yanchep, except 4 ha in the Spearwood sand unit
- a flood-secure building area of at least 1,000 m² on every lot.
Where land is identified for Water Catchment Reservation under the Gnangara Land Use and Water Management Strategy, the policy says the City "shall not support any further subdivision". DPS2 describes the Rural Residential zone as providing for lot sizes in the range of 1 ha to 4 ha. See also subdividing rural land and acreage.
Other local constraints
- Caves and karst. Local Planning Policy 4.13 applies to proposals affected by caves or karstic features. At subdivision, the City recommends a geotechnical report in high karst risk areas unless earlier investigations show otherwise, and may require a pre-works report certifying the land is physically capable of development.
- Heritage. The City's Heritage List, kept under clause 8 of the deemed provisions of DPS2, contains places in management categories 1A, 1 and 2 of its Local Heritage Survey. The City says proposals that may affect a listed place are advertised and sent to the Heritage Council for comment.
- Bush Forever and wetlands. In some zones, DPS2 says the City will not support proposals that adversely impact a designated Bush Forever site. The City also has local planning policies on wetlands, coastal assets and tree preservation.
- Bushfire. Check the DFES Map of Bush Fire Prone Areas. Designation can trigger State Planning Policy 3.7 where a proposal increases development intensity.
Developer contributions
The City has developer contribution arrangements for East Wanneroo Cells 1 to 9, Alkimos/Eglinton and Yanchep/Two Rocks. It says a Developer Contribution Plan is usually applied as a condition of subdivision or development, prepared under section 26 of the Planning and Development Act 2005 and State Planning Policy 3.6, and that it provides a quote before payment. Ask the City for the current rates. Our subdivision cost calculator gives a broader estimate of costs.
How subdivision approval works in Wanneroo
The City explains the process this way:
- Apply to the WAPC, not the City, through the WAPC's planning online portal.
- Referral. The City has 42 days to assess the application and tell the WAPC whether it complies with DPS2 and any relevant local policies, recommending support with conditions where it does.
- Decision. Approval is valid for 3 years for 5 lots or fewer, or 4 years for more than 5. Reconsideration can be sought from the WAPC within 28 days of the decision.
- Clearance. After the works are done, you apply to the City for subdivision clearance. If satisfied, it issues a clearance letter and a stamped, signed plan of survey.
- Endorsement and titles. The WAPC endorses the deposited or strata plan, which is then lodged at Landgate for new titles.
From 1 July 2026 the WAPC application fee for a freehold subdivision of two to 100 lots is $3,837 plus $85 per lot, and endorsement is $719 plus $8 per lot. For each step in more detail, see how to subdivide land in Western Australia.
Draft R-Codes changes (proposed, not in force)
The State Government released draft R-Codes on 24 October 2026. The Government's media statement says average lot sizes for R10 to R25 would be scrapped in Perth and Peel. Submissions close at 5.00pm (AWST) on Friday 26 February 2027, and the department expects amendments to begin coming into effect later in 2027, subject to consultation and approval. Applications continue to be assessed under the current framework.
Contacting the City of Wanneroo
The City's general enquiries line is (08) 9405 5000, and its Approval Services team handles planning advice. Its administration is at 23 Dundebar Road, Wanneroo, and its postal address is Locked Bag 1, Wanneroo WA 6946.
Check your own block
A Subdivision Checker report applies these rules to one address: planning and zoning, heritage, environment, contamination, bushfire, flood, servicing and access, measured lot geometry and concept subdivision design options, plus indicative cost ranges labelled as estimates. It is a starting point, not a substitute for advice from a licensed surveyor or town planner. To see how the checks are set out, view our sample report, or order a report for your address.
Frequently asked questions
Can I subdivide my block in Wanneroo?
It depends on your lot's zoning and density code (R-Code), and whether the lot meets the R-Codes Table D minimum and average site areas for that code. In Wanneroo the code may come from District Planning Scheme No. 2 or from an approved structure plan. Servicing, access, karst, bushfire and developer contributions can also affect the answer. The Western Australian Planning Commission (WAPC) decides, and a licensed surveyor or town planner can advise on a specific lot.
What is the minimum lot size for subdivision in the City of Wanneroo?
For residential land it follows the R-Code. Table D of the R-Codes Volume 1 sets a minimum and average site area per dwelling, for example 350 m² and 450 m² at R20, 260 m² and 300 m² at R30, and 180 m² and 220 m² at R40. Rural land is different: the City's Local Planning Policy 4.9 sets minimums such as 4 ha south of Neaves Road and 20 ha in parts of the Rural Resource zone north of Flynn Drive.
How does a split code like R20/R40 work in Wanneroo?
Under clause 4.2(4) of District Planning Scheme No. 2, development must conform to the lower code unless the City determines that the higher code is appropriate. Both of these criteria must be met: sufficient capacity in public utility services and no more than one consolidated vehicle access point for each street frontage. Subdivision of split-coded land should not need additional crossovers, and land directly abutting Wanneroo Road or Mirrabooka Avenue needs a Noise Management Plan with the subdivision application.
My Wanneroo lot is in a structure plan area. Where do I find its R-Code?
WAPC guidance says structure plans for residential areas must designate R-Codes on the structure plan map, and decision-makers give the plan due regard when deciding subdivision applications. Check the approved structure plan and any local development plan for your area. The City publishes its structure plans and local development plans online, and PlanWA shows structure plans approved by the WAPC after 19 October 2015.
Do I have to pay developer contributions to subdivide in Wanneroo?
In some areas, yes. The City has developer contribution arrangements for East Wanneroo Cells 1 to 9, Alkimos/Eglinton and Yanchep/Two Rocks. The City says a Developer Contribution Plan is usually applied as a condition of subdivision or development, and it provides a quote before payment. Ask the City for the current rates for your cell or area.
Are lot sizes in Wanneroo changing?
Changes are proposed but not in force. The draft R-Codes released on 24 October 2026 propose scrapping average lot sizes for R10 to R25 in Perth and Peel. Submissions close at 5.00pm (AWST) on Friday 26 February 2027, and the department expects amendments to begin coming into effect later in 2027, subject to consultation and approval.
Sources
- City of Wanneroo District Planning Scheme No. 2, scheme text (updated to Amendment 232, 6 October 2026)
- City of Wanneroo planning information: scheme text, maps and structure plans (DPLH)
- City of Wanneroo: Online mapping
- City of Wanneroo: Written planning advice
- City of Wanneroo: What is the subdivision process?
- City of Wanneroo: Approved structure plans and local development plans
- City of Wanneroo: Local planning policies
- City of Wanneroo Local Planning Policy 3.1: Local Housing Strategy Implementation
- City of Wanneroo Local Planning Policy 4.19: Medium-Density Housing Standards (R-MD)
- City of Wanneroo Local Planning Policy 4.9: Subdivision of Rural Zoned Land
- City of Wanneroo Local Planning Policy 4.13: Caves and Karstic Features
- City of Wanneroo: Developer contribution schemes
- City of Wanneroo: Heritage List
- WA Planning Manual: Guidance for Structure Plans (WAPC, August 2023)
- Residential Design Codes Volume 1 (Version 3, 10 April 2026)
- WAPC Subdivision Applications and Fees Guide (version 10.7, July 2026)
- PlanWA (Department of Planning, Lands and Heritage)
- Water Corporation: Infrastructure contributions
- Bushfire prone areas (DFES)
- Residential Design Codes Review (Department of Planning, Lands and Heritage)
- Residential Design Codes Review (Have Your Say WA)
- Changes to cut red tape for new granny flat developments (WA Government media statement, 24 October 2026)
This guide is general information only, current at November 2026. Rules, fees and maps change, and every block is different. Speak to a licensed surveyor or town planner about your property.
